Site survey
We check mounting points, signal, power and cable routes before anything is ordered, then confirm the scope in writing.
We survey the property, mount the devices, run the low-voltage wiring, configure the app and notifications, test everything, then hand over a working system — for homes and small businesses across Europe.
Every job is delivered by qualified electricians. We handle the physical work, the configuration and the explanation — you are not left holding a manual.
We check mounting points, signal, power and cable routes before anything is ordered, then confirm the scope in writing.
Devices are fixed to the right substrate, with low-voltage wiring and power connections made to the requirements that apply on site.
Recorder, app, motion zones, notifications and user accounts are set up and tested with you present.
Every channel is checked, footage and alerts verified, then you get a short walkthrough and the documentation.
Survey, mount, wire, configure, hand over. The photographs below are from the stages, not from a showroom.
The photographs are half the story. The other half is the paperwork that keeps a system understandable a year later:
The photographs are half the story. The other half is the paperwork that keeps a system understandable a year later:
The photographs are half the story. The other half is the paperwork that keeps a system understandable a year later:
The photographs are half the story. The other half is the paperwork that keeps a system understandable a year later:
The photographs are half the story. The other half is the paperwork that keeps a system understandable a year later:
We install what you have bought, or specify equipment for the property if you prefer to start from a clean sheet.
Wired or battery doorbells, chime modules, transformer checks where a wired unit needs one.
Indoor and outdoor cameras, fixed or PTZ, wall, soffit or pole mounting with cable routing.
Four to sixteen channels, recorder sited and configured, storage sized, remote viewing checked.
Low-voltage runs, PoE checks, switch and router settings that the cameras depend on.
Send a floor plan or a few photos. We mark up coverage, flag blind spots and return a device count — before you commit to equipment.
We work to local electrical safety requirements and the manufacturer's commissioning procedure for each device. Where a site needs a certificate from another party, we tell you before work starts.
Cable routes, containment and power connections are carried out by qualified electricians and inspected before devices are energised.
Firmware, storage and account setup follow the device maker's checklist, so warranty terms are not compromised by the install.
You receive device locations, account details, retention settings and a one-page summary of what was tested.
A doorbell that drops off the network or a camera that records nothing is usually a planning problem, not a hardware fault. We map the whole chain before mounting anything.
Typical values below. The survey confirms the actual figures for your property before anything is ordered.
Transformer and chime checked; 8–24 V AC per device requirement
Confirmed at surveyPoE or Wi-Fi, 2.4/5 GHz checked at each position
Confirmed at surveyLocal NVR or SD, retention agreed at survey
Confirmed at survey1–16 cameras per site, single recorder
Confirmed at surveyOwner account plus shared users, set at handover
Confirmed at surveyScopes below are typical of the work, not published client references. Named references are provided on request with the client's consent.
Doorbell plus four external cameras
Two-storey property, cameras on soffits, recorder in the utility room, app on two phones.
Entrance, till and stockroom coverage
Six-camera system with 30-day retention, staff accounts separated from owner access.
Door entry and corridor cameras
Wired doorbell at reception, three indoor cameras, notifications routed to the facilities lead.
Power connections and low-voltage wiring are done by qualified electricians, which matters the moment a wired doorbell or a long cable run is involved.
We would rather tell you that two cameras are enough than sell six. The survey exists to prevent equipment that does not fit the property.
Motion zones, notification rules, retention and user accounts are part of the job, not a paid extra after the installers leave.
We install and commission. We do not run a monitoring station, answer alarms, or take responsibility for how footage is used afterwards.
ECO POWER GROUP LTD installs and commissions doorbells and cameras for homes and small businesses. The same people survey, install and return for maintenance — nothing is subcontracted to a crew you have never met.
We publish the kit rather than stock portraits. The people who arrive are the electricians and the commissioning technician named in your quote.
Most homes are completed in a single visit. Larger sites are split across two days, agreed before booking.
On site or remote with photos. We confirm positions, power, network and scope, then send a written quote.
Date agreed, equipment confirmed, access and parking arranged. You know who is arriving and when.
Mounting, wiring and configuration on the day. Floors and surfaces protected, dust kept to a minimum.
Every channel tested with you present, app walkthrough, documentation left on site.
Devices drift: firmware updates reset a notification rule, a camera loses focus, storage fills. We offer a yearly check and a call-out option, priced separately from the installation.
Travel is quoted per project. For sites outside our usual range we confirm access, parking and any local requirements before the date is agreed.
For sites outside our usual range we confirm access, parking and any local requirements before the date is agreed — travel appears as its own line on the quote, never hidden in the installation price.
Entrance and parking arrangements, whether the landlord or building manager must approve external fixtures, and who will be present at handover — all settled at survey, not on the day.
The full list, including device and privacy questions, is on the FAQ page.
Send the basics and we will come back with the next step: a survey date, a device list, or a straight answer that you do not need us.
Or call +44 1638 583 274
Mon–Fri 08:00–18:00 CET
Book a survey, or send the details and we will tell you what the property actually needs.
We use essential cookies to run this site. With your permission we also use analytics cookies to understand which pages help visitors. You can change your choice any time.